Paper Title :Design, Development And Analysis Of Forming Tool For Side Panel Of An Automobile
Author :Ulhas K Annigeri, Y P Deepthi, Raghavendra Ravi Kiran K
Article Citation :Ulhas K Annigeri ,Y P Deepthi ,Raghavendra Ravi Kiran K ,
(2014 ) " Design, Development And Analysis Of Forming Tool For Side Panel Of An Automobile " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 30-33,
Volume-2,Issue-6
Abstract : Abstract- The design, development and structural analysis of forming tool for a side panel of an automobile is carried out in
this endeavor. The design protocol is on conventional lines, based on tried and tested norms developed through expertise and
experience reported in literature and design chapters. Solid works 2003, Auto CAD R2004 software has been used for
modeling and detailing. Finite Element Analysis package Ansys5.4 has been used to determine the stresses that are induced
in the Forming tool. This paper gives a brief overview of fabrication of tool, tool cost estimation and finally an insight into
the stresses induced in the forming tool.
Type : Research paper
Published : Volume-2,Issue-6
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-781
View Here
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 58 |
| |
Published on 2014-06-02 |
|
