Paper Title :A Study on Micro Hardness in Wire Electrical Discharge Machining Based on Taguchi Method
Author :Noor Zaman Khan, Mohd Atif Wahid, Satyaveer Singh, Arshad Noor Siddiquee, Zahid A. Khan
Article Citation :Noor Zaman Khan ,Mohd Atif Wahid ,Satyaveer Singh ,Arshad Noor Siddiquee ,Zahid A. Khan ,
(2013 ) " A Study on Micro Hardness in Wire Electrical Discharge Machining Based on Taguchi Method " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 10-15,
Volume-1,Issue-1
Abstract : Wire electric discharge machining (WEDM) is a widely accepted non-traditional material removal process for
manufacturing of components with intricate shapes. In the present work, an investigation into the wire electric discharge
machining of high strength and low alloy (HSLA) steels has been carried out. HSLA steels provide better mechanical
properties and greater resistance to atmospheric corrosion. Experimentation has been done using Taguchi’s L
9 orthogonal
array. Each experiment was conducted under different combinations of pulse on time, pulse off time and peak current.
The optimum machining parameter combination was obtained by using the analysis of signal-to-noise (S/N) ratio, analysis of
means and analysis of variance (ANOVA). Further, the level of importance of the machining parameters on micro-hardness
was determined by using ANOVA. The study shows that the Taguchi’s method is suitable to solve the stated problem with
minimum number of trails.
Type : Research paper
Published : Volume-1,Issue-1
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-341
View Here
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 76 |
| |
Published on 2014-01-23 |
|
