Paper Title :Study of design & development of oxygen supply System for CNC gas cutting machines

Author :Sujay Kulkarni

Article Citation :Sujay Kulkarni , (2015 ) " Study of design & development of oxygen supply System for CNC gas cutting machines " , International Journal of Mechanical and Production Engineering (IJMPE) , pp. 135-139, Volume-3, Issue-11

Abstract : In heavy fabrication company, manufacturing of boiler and cement shells, CNC gas cutting machine is regularly used for various plate cutting operation. Such machines require oxygen and acetylene gases with proper pressure controls. For gas cutting machine, volume of oxygen gas used is more than that of acetylene gas. The oxygen gas is used for heating and cutting the plates. It is necessary to supply the proper amount and quality of gas to the machine to obtain good cutting quality of plates. Even the pressure of oxygen gas depends upon the thickness of cutting plates. Previously using twelve cylinders manifold and common pipeline for both the gas cutting machine was common. In this system, the cylinder gets empty in 16 hours, so after every 16 hours there was a necessity of changing the twelve cylinders. Thus, the paper presented provides us with the detailed information about the automated oxygen supply system called oxygen bullet Thus, the paper presented provides us with the detailed information about the automated oxygen supply system called oxygen bullet Keywords- Oxygen Bullet, Piping Systems, Vessel Dimensions, Pressure Ratings And Burst Strength.

Type : Research paper

Published : Volume-3, Issue-11

	|		PDF	|	Viewed - 100	|	Published on 2015-11-22