Paper Title :Effects of Cutting Parameters on Edge Features of Steel Rod Cut by Punch/Dieshearing
Author :Pirapa Natpukkana, Pusit Mitsomwang, Rattana Borrisutthekul,Rungnapa Panuwannakorn, Lertchai Khao-Phong
Article Citation :Pirapa Natpukkana ,Pusit Mitsomwang ,Rattana Borrisutthekul ,Rungnapa Panuwannakorn ,Lertchai Khao-Phong ,
(2018 ) " Effects of Cutting Parameters on Edge Features of Steel Rod Cut by Punch/Dieshearing " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 39-45,
Volume-6,Issue-5
Abstract : Typically, theedge features of steel rod cut by punch/die shearing determine the quality and the application of the
sheared products. In this study,the authors aim to investigate the effects ofa shearing parameter, punch/die clearance, on the
cutting load resistanceand the edge features of shearedrod.A JIS SCM420steel rod was chosen as the material for the
investigation. The punch/die clearance was experimentally varied from 40 to 250 m.Cutting results, the cutting load
resistance, the features of sheared edges, were examined. In addition, the finite element method (FEM)analysis was conducted
to simulate the stress distribution in the sheared rod.Form the investigation results, it was found that the sizes of rolloverand the
burr zones formedat the sheared edge significantlyincreased with the clearance. Also, from the shearing simulation, the
variation of the rollover zone size seemed to be explained by the maximum principal tensile stress near the edge of the cutting
tools.
Index Terms - Three-Dim. Cutting, Rod, Shearing,Burr, Wear
Type : Research paper
Published : Volume-6,Issue-5
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-12459
View Here
Copyright: © Institute of Research and Journals
|
|
| |
|
PDF |
| |
Viewed - 77 |
| |
Published on 2018-08-02 |
|