Paper Title :Optimization Of Cutting Parameters To Minimize Machining Time In CNC Turning Of 34crnimo6 Alloy Steel Using Taguchi Method
Author :Rahul Borate, Baliram Jadhv, A. Chougule
Article Citation :Rahul Borate ,Baliram Jadhv ,A. Chougule ,
(2014 ) " Optimization Of Cutting Parameters To Minimize Machining Time In CNC Turning Of 34crnimo6 Alloy Steel Using Taguchi Method " ,
International Journal of Mechanical and Production Engineering (IJMPE) ,
pp. 16-19,
Volume-2,Issue-7
Abstract : This research work is carried out at Bharat Forge Ltd Satara. In the company heavy duty work pieces are machined
on CNC machines. It requires more time to machining. In the present study, optimization of cutting parameters to minimize
machining time in CNC turning of 34CrNiMo6 alloy steel material is discussed. The Taguchi method of optimization is used
with a Two Factor-Three level L9 Orthogonal array design. The experimental runs are taken & machining time is recorded.
The results are analyzed in MINITAB software using S/N ratio plots. The results Shows that the feed affects more to the
machining time than Cutting speed. Higher values of feed & cutting speed give lesser machining time. Finally the optimal
values of cutting parameters are given
Type : Research paper
Published : Volume-2,Issue-7
DOIONLINE NO - IJMPE-IRAJ-DOIONLINE-1020
View Here
Copyright: © Institute of Research and Journals
| |
 |
| |
 |
PDF |
| |
Viewed - 57 |
| |
Published on 2014-07-04 |
|
